Messerschmitt Bf109G-10/U4 panel

Benutzeravatar
Die13
Beiträge: 179
Registriert: 29 Jan 2020 12:23
Wohnort: Deutschland
Re: Messerschmitt Bf109G-10/U4 panel

Beitrag von Die13 »

Hier ein Foto...
Du hast keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.

baturavgan
Beiträge: 29
Registriert: 04 Mär 2020 13:18
Re: Messerschmitt Bf109G-10/U4 panel

Beitrag von baturavgan »

Die13 hat geschrieben:
15 Mär 2020 10:47
Hier ein Foto...
Hello Harald,

As far as I see, Matthias has one of the dataplates which I produced several years ago. The colors on this plate were wrong.

However, while the colors shown at Helmut Vogt's drawings were correct, his plates for "G-4 to G-6" and "G-6 to G-10" were completely fictional. They did not exist. I attach a drawing of the correct dataplate which I prepared from the Messerschmitt factory blueprint. This is the version used after October 1942 and updated in December 1943. I know that 2 versions of this plate were used, with and without (seen here) frames.

Regards,

batur
Zuletzt geändert von baturavgan am 15 Mär 2020 21:19, insgesamt 1-mal geändert.

Benutzeravatar
Die13
Beiträge: 179
Registriert: 29 Jan 2020 12:23
Wohnort: Deutschland
Re: Messerschmitt Bf109G-10/U4 panel

Beitrag von Die13 »

Hello Batur,

This is ok! There are several variants at the manufacturers. The color scheme and division are important.

greetings

Harald

Benutzeravatar
Matthias
Beiträge: 20
Registriert: 28 Jan 2020 19:52
Re: Messerschmitt Bf109G-10/U4 panel

Beitrag von Matthias »

I bought this sign in 2007 in Speyer from Jiri. If there is more detailed knowledge of the correctness today, it is time to buy the right sign. Where can I get an etched, correct sign from?

best regards
Matthias

baturavgan
Beiträge: 29
Registriert: 04 Mär 2020 13:18
Re: Messerschmitt Bf109G-10/U4 panel

Beitrag von baturavgan »

Matthias hat geschrieben:
15 Mär 2020 20:13
I bought this sign in 2007 in Speyer from Jiri. If there is more detailed knowledge of the correctness today, it is time to buy the right sign. Where can I get an etched, correct sign from?

best regards
Matthias
Matthias, I am going to make a few acid-etched sets next week. If you are interested, you can send me a PM.

Regards,

Batur

Benutzeravatar
Die13
Beiträge: 179
Registriert: 29 Jan 2020 12:23
Wohnort: Deutschland
Re: Messerschmitt Bf109G-10/U4 panel

Beitrag von Die13 »

Hello Batur and Matthias,
I already have several of these personal rights and you were told that it was wrong and was correct. You ignored it! I think it's good Batur that you're doing some for Matthias. If you have any questions about 109, please answer them for yourself.


Antworten